I apologize if this topic now seems redundant, but any type of clarification would be great.
I recently purchased a few of the Vienna Instruments to be used in my studio. I currently run an apple Dual Core G5 with Pro Tools as my main recording environment.
I understand the problem of VI currently only available as VST and AU, and not in RTAS. I spoke with a representative from ilio as well as a couple of VSL representatives at licensed dealers in the area--and they assured me that if i purchased Fxpansion's VST-RTAS Adapater 2.0, I would be able to use the VIs within Pro Tools as 'wrapped' RTAS after conversion. I was still a bit skeptical as I contemplated 'well, I have a Mac, so how will I be able to access the VST files?'. However, I trusted the information given to me as I did give each person I spoke to, the details of my set up.
So I installed the Solo Strings VIs onto my system last night. Installation went well. Then, I ran the adapter program. Obviously, it was unable to read and wrap the files that were on my system.
This makes sense right? Or has anyone else tried the Fxpansion route on a mac? Any suggestions? Am I missing a step?
What other creative solutions are there to enable VI within Pro Tools?
Do I really have to purchase Logic to use the VI?
Thanks for your help.
-Nathan
I recently purchased a few of the Vienna Instruments to be used in my studio. I currently run an apple Dual Core G5 with Pro Tools as my main recording environment.
I understand the problem of VI currently only available as VST and AU, and not in RTAS. I spoke with a representative from ilio as well as a couple of VSL representatives at licensed dealers in the area--and they assured me that if i purchased Fxpansion's VST-RTAS Adapater 2.0, I would be able to use the VIs within Pro Tools as 'wrapped' RTAS after conversion. I was still a bit skeptical as I contemplated 'well, I have a Mac, so how will I be able to access the VST files?'. However, I trusted the information given to me as I did give each person I spoke to, the details of my set up.
So I installed the Solo Strings VIs onto my system last night. Installation went well. Then, I ran the adapter program. Obviously, it was unable to read and wrap the files that were on my system.
This makes sense right? Or has anyone else tried the Fxpansion route on a mac? Any suggestions? Am I missing a step?
What other creative solutions are there to enable VI within Pro Tools?
Do I really have to purchase Logic to use the VI?
Thanks for your help.
-Nathan