Vienna Symphonic Library Forum
Forum Statistics

193,985 users have contributed to 42,905 threads and 257,892 posts.

In the past 24 hours, we have 4 new thread(s), 17 new post(s) and 88 new user(s).

  1. Home
  2. Software
  3. Vienna Ensemble Pro 7
  4. VE PRO 7 configuration help request Mac Master / Pc Slave + shared Internet

  • VE PRO 7 configuration help request Mac Master / Pc Slave + shared Internet

    S
    S

    Hello everyone!

    I'm looking for a little help to properly configure my new system consisting of :
    a PC (the slave-Win11) and Mac (the master) and a shared internet connection.

    I have no trouble getting the two computers to communicate with each other, and everything works in VE Pro 7 (with just an ethernet cable between the two).

    On the other hand, where I get stuck (and I don't dare make any changes yet) is on the Internet connection sharing.

    Let me explain: wifi reception is very poor in my studio, so I have to use a wired connection. How can I get Internet access on both computers, while keeping my fixed IP addresses 192.168.0.X with subnet mask 255.255.255.0?

    Is this possible ? Ideally, the Internet should arrive on the Mac and then go back to the PC, but I don't mind the other way round.


    I also have a small ethernet switch (not yet in use)

    Any advice? Thanks a lot!
  • T
    T

    Another Network card perhaps? Or a WiFi range expander. readily available on Amazon I am certain.

    @Sigeo2020 said:

    Hello everyone!


    I'm looking for a little help to properly configure my new system consisting of :
    a PC (the slave-Win11) and Mac (the master) and a shared internet connection.


    I have no trouble getting the two computers to communicate with each other, and everything works in VE Pro 7 (with just an ethernet cable between the two).


    On the other hand, where I get stuck (and I don't dare make any changes yet) is on the Internet connection sharing.


    Let me explain: wifi reception is very poor in my studio, so I have to use a wired connection. How can I get Internet access on both computers, while keeping my fixed IP addresses 192.168.0.X with subnet mask 255.255.255.0?


    Is this possible ? Ideally, the Internet should arrive on the Mac and then go back to the PC, but I don't mind the other way round.



    I also have a small ethernet switch (not yet in use)


    Any advice? Thanks a lot!