Hello,
I have just tested and failed to play smooth when I set all mic positions using 1a to 7a in VI Pro cells with each single patct. (Close, Mid L+R, Main L+R, Main Center + Back + Main Ls+Rs, Auro HL+HR, Auro HLs+HRs)
Yes, I know it's abnormal and maybe beyond software's limit. But even if I did this with my computer(Octa Core, SSD, 64GB RAM and so forth), it was very hard to play 4 notes simultaneously. As I tried to play Major 7th Chord, the fourth note sounded not very well, not to say, silent. The settings of latency and voices were enough to play.
Even when I tried to move notes one another, it stopped once for very short time and started to sound again, just like playing immediately after releasing.
So I attempted to reduce the mics one by one. It was not until any of 2 mic left that it sounded with no problem. Is this why 'Room-Mix' preset was made of only 2 mics combined ? Using over 3 mics at the same time (especially Long patches) within one cell in VI Pro causes unexpected internal algorithm issue ?
I wonder each mic has to be used saperately or the intended use of maximum mics positions is one or two simultaneously.