Vienna Symphonic Library Forum
Forum Statistics

194,525 users have contributed to 42,922 threads and 257,973 posts.

In the past 24 hours, we have 1 new thread(s), 5 new post(s) and 96 new user(s).

  1. Home
  2. Software
  3. Vienna MIR & Vienna Suite
  4. Mir Pro24 and Studio one V4 Prof

  • Mir Pro24 and Studio one V4 Prof

    M
    M

    Hi,

    i have a problem which i can´t solve. I have createt a orchestral template in Studio one prof and routed the reverb mostly on the bus chanels with MirPro24. I have setup the reverb on the grafic side of MirPro with all the directions etc... but most of the time the reverb was gone when i start a new session and the instruments where completely dry without reverb. I can´t see any reactions when i open MirPro in the inserts...

    At the moment the only solution to get back the reverb in th bus chanles was to delet the insert of MirPro and create a new insert but on the next time the reverb doesn´t work either it was shown in the inserts but that was very frustrating and a waste of time. Can someone help my to get this problem solved?

    Best regards.

    Bernd
  • DietzD
    VSL Team
    DietzD

    Hi Bernd,

    I have no first-hand experience to rely on when it comes to Studio One, so I can just guess what's wrong.  First of all - could you please tell us to what size the MIR engine's latency is set to in its Preferences? While you're at it: Is "Dynamic Processing" switched on or off there?

    Apart from that: What's the global latency of your audio driver set to? Is there some nifty "pre-processing" done by Studio One to reduce the actual CPU load? Do you run into the same problem when you use MIR Pro in audio channels directly, rather than in busses?

    /Dietz - Vienna Symphonic Library
  • M
    M

    Hi Dietz,

    first thank you for your help. I have tried to attach a screenshot from the Mirx settings and the settings of my Audiobox. A Presonus speciality is the low latency monotoring which allos you to reduce your latency, this i what i have switched on.

    This phenomen you can see on both, on bus chanels or on single instruments. At the moent i try to record a cornet which i have positioned on the balcony in the back, so i can´t use the normal brass reverb from the "normal" positioned brass instruments but i have stopped it. I have first to solve this problem. I use a Windows 10, 64 bit system.

    Image

    Image
  • M
    M

    Good morning Dietz,

    i´ve tried so change the latenca on my Audiobox device and in the MIrx settings without success. Have you some idea? I think i create a ticket.

    Best regards.

    Bernd
  • DietzD
    VSL Team
    DietzD

    Yes please, it's certainly the best idea to get in contact with VSL's support team directly. I have no means to test Studio One here at the moment.

    All the best,

    /Dietz - Vienna Symphonic Library