Vienna Symphonic Library Forum
Forum Statistics

194,301 users have contributed to 42,914 threads and 257,952 posts.

In the past 24 hours, we have 0 new thread(s), 17 new post(s) and 81 new user(s).

  1. Home
  2. Software
  3. Vienna MIR & Vienna Suite
  4. Sends or inserts?

  • Sends or inserts?

    J
    J

    Wich way is preferred to add instrument placement within the orch?

    Using sends to different reverbs ( withh 100% wet) or sending the complete signal to different reverbs, adjusting just the wet level?
  • Beat KaufmannB
    Beat KaufmannB
    last edited
    last edited

    @johram said:

    Wich way is preferred to add instrument placement within the orch?

    Using sends to different reverbs ( withh 100% wet) or sending the complete signal to different reverbs, adjusting just the wet level?

    Hello and welcome in this Forum, dear Johram!

    Your question is probably discussed in a lot of forums more than one time. But you asked "which way is prefered?"

    I prefer to create several depths with all the additions for a perfect simulation (the farther the darker for example).

    Then I route the certain instruments though their corresponding depth.

    The use of some depths can help to get a good transparence of large ensembles.

    Best

    Beat

    - Tips & Tricks while using Samples of VSL.. see at: https://www.beat-kaufmann.com/vitutorials/ - Tutorial "Mixing an Orchestra": https://www.beat-kaufmann.com/mixing-an-orchestra/
  • J
    J

    Thanks Beat.

    Yes this is the way I prefer too. 

    I realize the question must be covered lots of times, just couldnt find it.

    I am trying to figure out the most flexible setup ... It all depends on the type of project, like if you suddenly want to change the depth of one instrument in a group.

    All the best / J
  • M
    M

    If you're talking reverb, I use almost exclusively 'sends'. With an insert, you're only getting the benefit of one instrument per that 'inserted' reverb. So CPU wise this could be a lot of power wasted. Also, I make any channel sending the signal to this reverb a pre-fader channel so that I can control the perceived distance of the instruments by dropping out the direct signal via the channel's fader.

    About sending pre-fader/post fader, I don't know that it makes a huge difference. In both instances you're merely adjusting the wet/dry ratio right? Just using different controls to adjust it.

    I've been experimenting with an insert reverb, though, on the Master Out channel (Hybrid Reverb!! Fantastic 'verb) -- an overall reverb tail to blend. Not sure if it's working to my advantage yet though.

    Mahlon